Key takeaways
- Use three timeframes with separate jobs: bias, zone and entry.
- The higher timeframe decides direction; the lower timeframe only decides timing.
- Wait for price to reach the higher-timeframe order block before looking for a lower-timeframe entry.
- The lower-timeframe CHoCH inside the zone is the signal that the pullback may be ending.
A 15-minute order block on its own is a coin flip with extra steps. The same block sitting inside a 4-hour order block, in the direction of the daily trend, is a very different idea. Multi-timeframe analysis is how you tell those two situations apart.
Why one timeframe is not enough
Every timeframe has its own structure. The 15-minute chart can be in a clean downtrend while the 4-hour is in an uptrend — because the 15-minute is just showing you a pullback. If you only look at the small chart, you will keep selling into higher-timeframe support. If you only look at the big chart, your stops will be huge.
Pick a timeframe stack
| Style | Bias | Zone | Entry |
|---|---|---|---|
| Swing | Daily | 4H | 1H |
| Intraday swing | 4H | 1H | 15m |
| Day trading | 1H | 15m | 5m |
Pick one stack and stay with it. Switching timeframes mid-trade to find a reason to stay in is a habit worth avoiding.
The four-step process
- Bias. On the highest timeframe, read the last BOS or CHoCH. Bullish structure means you only look for longs this session; bearish means only shorts.
- Zone. On the middle timeframe, mark the fresh order block that agrees with the bias. Set an alert at its edge and walk away.
- Trigger. When price enters the zone, switch to the entry timeframe. Wait for a CHoCH in your direction — the first sign that the pullback has run out of steam. The order block created by that CHoCH is your precise entry.
- Manage. Stop below the middle-timeframe zone (safer) or below the entry-timeframe block (tighter). Target the nearest liquidity on the middle timeframe.
Walk-through example
Here is how the process plays out on an intraday swing stack (4H / 1H / 15m):
- The 4H chart has just printed a bullish BOS. Bias: long.
- On the 1H, the order block that launched that BOS sits about 3% below the current price. You set an alert at its top.
- A day later the alert fires. On the 15m chart, price is still making lower lows — the pullback is in progress. You do nothing.
- Two hours later, a 15m candle closes above the last lower high: a CHoCH. The last red candle before that move is a small 15m order block.
- The entry goes at that 15m block, with the stop below the 1H zone and the target at the 4H buy-side liquidity.
Because the entry is refined on the 15m but the stop protects the 1H zone, the trade often offers a reward-to-risk of 3R or more. Check yours with the risk reward calculator.
Run the scanner on the 4H or 1H timeframe and filter by direction to find coins sitting near fresh zones. Then open only those charts on the lower timeframe.
Common mistakes
- Entering at the zone edge without a trigger. Many zones are pierced before they react; the lower-timeframe CHoCH filters some of that out.
- Letting the lower timeframe overrule the bias. A 5m bearish BOS does not cancel a daily uptrend.
- Using too many timeframes. Three is plenty. Five creates permanent disagreement.
Frequently asked questions
What is a good timeframe combination for crypto?
Common stacks are Daily / 4H / 1H for swing trading, 4H / 1H / 15m for intraday swing trades, and 1H / 15m / 5m for day trading. A ratio of roughly 4 to 6 between each step works well.
What if the timeframes disagree?
They usually do at some point. The higher timeframe wins for direction. If the lower timeframe is moving against it, that is normally a pullback — which is exactly the move you are waiting to end.